EpoxyPlus TE2
High performance pure epoxy anchoring mortar
EpoxyPlus TE2 is a high performance, non-shrink, pure epoxy resin that is ideal for bonding metal components into masonry, concrete and rock. It is supplied in a two part, nozzle-mixed cartridge format for consistent quality and easy use.
EpoxyPlus TE2 has been formulated to provide superior bonding security and good working time even in warm conditions. EpoxyPlus TE2 is a low slump, thixotropic resin and is suitable for horizontal and vertical injection.
Applications
- Anchoring metal fixings, including threaded rods and starter bars, into masonry type substrates including bricks, blocks, stone, concrete and rock.
- Anchoring remedial wall ties into masonry type substrates including bricks, blocks, stone, concrete and rock. Learn more...
Features and Benefits
- Non-shrink, thixotropic resin.
- Ideal for overhead or horizontal use.
- Flows easily under pressure.
- Rapidly develops compressive and tensile strength.
- Two part nozzle-mixed resin for consistent quality.
- Long work time even in warm conditions.
- Gels rapidly and cures within 24 hours.
- Supplied in 250ml part-useable cartridges.
- Useable in standard mastic gun.
Technical Data
Performance dataSetting times
Temp.
- 5°C
- 20°C
- 30°C
Gel time
- 150 mins
- 30 mins
- 15 mins
Service load time
- 24 hrs
- 8 hrs
- 4 hrs
Typical performance
12mm diameter bolt, 110mm deep in 14mm diameter hole 30MPa concrete: characteristic tensile load 46.0kN.
250ml part-useable cartridge
StorageStore in cool, dry, frost-free conditions, away from direct sunlight, between +5°C and +20°C.
MaterialsEpoxy resin and hardener.
Applicators and Accesories
Standard mastic gun
Hole cleaning brushes
Installation into solid masonry and concrete
-
Drill a clearnce hole into the subsrate to the correct diameter and depth.
-
Clean the hole of spoil and dust using an airjet or brush.
-
Inject EpoxyPlus TE2 to the back of the hole.
-
Immediately insert fixing with a twisting motion.
-
Leave to cure.
-
Attach fixture and tighten nut.
Installation into hollow masonry
-
Drill a clearnce hole into the subsrate to the correct diameter and depth.
-
Insert a perforated sleeve into the hole.
-
Completely fill the sleeve with EpoxyPlus TE2.
-
Slowly insert fixing with a twisting motion.
-
Leave to cure then attach fixture and tighten nut.